Page 10 - 普慧2020刀把(電子書版)

普慧刀把品質 Our Quality

材質 硬度 表面粗糙度 深冷處理 錐柄精度 偏擺精度 研磨設備 檢驗方式 動平衡
Material Hardness Surface Finish Cryogenic Shank Quality Run-Out Grinding Inspection Balancing
on Taper Treatment Tolerance Machines
Steep Taper 55~58 Hrc Ra. 0.15 µm -180 Degrees AT3 or Better Same as Indicated State of the Art 100% Checked Actual Balanced
NiCrMo Depth of Than DIN69893 in Catalogue from Swiss with Certified with Balanced
HSK/ Premium Min. 0.8 mm Gauge by Trained Machines
Chucks Higher
Technicians
Right Tool for Other Grade 50~55 Hrc Ra. 0.2 – 0.4 µm Nil or Only AT4 or Out of Often Different as Normal Grinder Radon Inspection Only Pre-Balanced
CrMo
NiCrMo
Depth of
Balanced
Gaugeby Non
Min. 0.6 Sub-Zero DIN 69893 Indicated in with Non Certified but Claimed
Catalogue
(-90)
your Job !
Trained Employees
超冷處理 Cryogenic Treatment
可將刀把內部殘留之沃斯田鐵 (AUSTENITE) 變成麻田散鐵 (MARTENSITE)，其可變態之組織可 經過超冷處理後金相圖
達97~98%。右圖為兩片同材質，但不同熱處理之金相圖。 Constitution diagram after
cryogenic treatment
刀把如經深冷處理, 其壽命及穩定度遠超過未處理之材質。
本公司產品經深冷處理之產品有 HY,CR,PFC 等。
To eliminate the stress after quenching and machining,and also prevent thermal shock. The
austenite almost fully transforms into martensite ( around 97％~98％ ).Cryogenic treatment 未經過超冷處理之金相圖
makes tool holders better wear resistance,no deformation,and no change in hardness over time Constitution diagram without
cryogenic treatment
to further improve the stability and life of tool holders.
Tool holders with cryogenic treatment are HY, CR, PFC etc.

8