Page 25 - 普慧2020刀把(電子書版)

電動增速器 馬達 增速器與周邊之組合

內藏式
Spindle Speeder and Accessaries
實現精準，安定，穩定，高馬力之目標
大幅提高原機台主軸轉速至30,000RPM的經濟方案

FAST PRECISE
The Most Economic Solution 轉速高 30,000 RPM 2µm 精度高 2‰m
For Upgrading to H.S.C.
TWO FACE CLOSLY CONTACT, POWERFUL
STRONG RIGIDITY 3kw 馬力大 3.0 kw
二面承靠剛性佳
LOW VIRATION, LOW NOISE
振動低，噪音低
S1130+周邊
S1010+變頻器 Inverter (含冰水機及變頻器） Control Unit

S1130 增速器安裝程序
S1130 S1010 Setup Procedure for S1130
• 30,000RPM • 24,000RPM
• 3.0kw • 1.0kw
• 偏擺 2µ • ਋ᓖ 2µ
• RUN OUT 2µ • RUN OUT 2µ
• 水冷 Water • 風冷 Fan

擦拭主軸內、外錐孔 設定主軸不自轉程式
Wipe taper. Set the non-rotate of
machine spindle.
注意！此步驟非常重要
Important!

特 點 Feature
● 內藏高頻馬達,轉速可達三萬轉，機台 ● The built-in high frequency motor is
directly driven by the converter to obtain
主軸不必轉動，無齒輪噪音，可24小 the steeples R.P.M.
時運轉 ● Directly mounted on the machine spindle
● 高出力可做熱處理後模具鋼之加工 without rotating it. 安裝高速頭(如同安裝刀把) 電控箱置於操作盤下
Put the control unit
Install the spindle.
● 可運用兩面承靠刀把，提高主軸整體剛 ● High output power, cutting on the (as same as install tool holder) under the panel.
heat-treated mould steel is available.
性
● Can be adapted with two faces closely
● 極低震動，精加工品質佳 contact tool holder to increase the
rigidity of the spindle.
● 可取代特殊放電加工，更可免除電極之
● Low vibration, high machining quality.
製作
● Special E.D.M. can be substituted to
● 安裝簡便，不費時
eliminate the machining of the electrode.
● Easy installation, time saving. 接高速頭側電源 將電控箱冷卻水管接在主軸
Connect the line and Connect the cooling pipe
pipe. of control unit to the
spindle.

只要在一般CNC機台裝上電動增速器，立刻升級為數
控高速模具加工機。

Install the electrical high speed booster on
the conventional machining center, it
will be upgraded to high speed 將電源線接在電源箱上 啟動主軸，開始加工
mold machine. Connect the cable to Turn on and start maching.
source box.

23